Avaya DEFINITY Server CSI Maintenance Manual page 1267

IPMEDPRO (IP Media Processor Circuit Pack)
Notes:
a. Error Type 1 - indicates that the circuit pack has been removed from the
system or is not fully administered. The alarm is logged about 15 minutes
after the circuit pack has been removed, or 11-minutes after the
(#53) fails.
To be fully administered, a IPMEDPRO circuit pack must meet all of these
4 conditions:
1. Have an entry in the circuit pack form (change circuit pack)
2. Have the MedPro ip address administered (change node-names)
3. Be enabled (change ip-interface)
4. Be physically inserted into the correct slot
If the circuit pack has an entry in the circuit pack form and either of the
other two conditions are not met, a MINOR alarm is logged. To resolve the
error:
1. Make sure all conditions for administration are met and that a
2. Completely remove the IPMEDPRO from the system using the
b. Error Type 18 -The IPMEDPRO Interface circuit pack has been busied out
by a busyout board UUCSS command.
1. Release the circuit pack (release board UUCSS).
c. Error Type 23 -The IPMEDPRO circuit pack is not completely
administered. To be fully administered, an IPMEDPRO circuit pack must
meet all of these 4 conditions:
1. Have an entry in the circuit plan (change circuit pack)
2. Have the IPMEDPRO IP address administered (change
3. Be enabled (change ip-interface)
4. Be physically inserted into the correct slot.
A DS1 (IPMEDPRO, MEDPRO, MAPD, UDS1-BD and DS1-BD) differs
from most circuit packs in that inserting the circuit pack into the switch is
not enough to make the board usable. It must also be administered.
555-233-119
functioning MedPro circuit pack is inserted in the correct slot
OR
following steps:
a. Remove the administered
circuit pack.
b. Physically remove the circuit pack from the slot.
c. Execute the remove medpro UUCSS and change circuit
pack UUCSS commands.
node-names)
associated with the
IP-Interface
Issue 5 October 2002
Test
SAKI
1267