Avaya DEFINITY Server CSI Maintenance Manual page 1264

Demand Reset Test (#704)
This test is destructive.
This action initializes the I/O Processor, and the firmware runs a comprehensive
set of diagnostic tests. This action will abort if the I/O Processor is in the in-service
state. The I/O Processor is put in the out-of-service state automatically if it has
been reset three times by background maintenance within the last 15 minute,
independent of the reset action.
Table 297. TEST #703 Demand Reset Test
Error Test
Code Result
1362 ABORT The test is not allowed to run because the I/O Processor is in-service. Running
this test is not allowed because it is destructive.
2000 ABORT Response to the test request was not received within the allowable time period.
Any FAIL The I/O Processor diagnostic tests failed.
PASS The I/O Processor diagnostic tests passed.
1264
Issue 5 October 2002
Description/ Recommendation
1. Use the display alarms command to determine the service state of the I/O
Processor. If the state is OUT, try the reset command again.
1. Retry the command at 1-minute intervals, a maximum of 3 times.
1. Retry the command.
2. If the reset fails, replace the Processor circuit pack.
Continued on next page
555-233-119