Avaya DEFINITY Server CSI Maintenance Manual page 634

Maintenance Objects
Table 34. TEST #6 NPE Crosstalk Test
Error Test
Code Result
ABORT
1000 ABORT
1001 ABORT
1002 ABORT
1003 ABORT
1004 ABORT
1005 ABORT
1018 ABORT
634
Issue 5 October 2002
Description/ Recommendation
Could not allocate the necessary system resources for this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
System resources required to run this test are not available. The port may
be busy with a valid call. Use display port PCSSpp to determine the
station extension. Use status station to determine the service state of the
port. If the port is in use, it is unavailable for certain tests. Wait until the port
is idle before testing.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
The system could not allocate time slots for the test. The system may be
under heavy traffic conditions or it may have time slots out-of-service due to
TDM-BUS errors. Refer to TDM-BUS Maintenance documentation to
diagnose any active TDM-BUS errors.
1. If system has no TDM-BUS errors and is not handling heavy traffic,
retry the command at 1-minute intervals a maximum of 5 times.
The system could not allocate a tone receiver for the test. The system may
be oversized for the number of tone detectors present or some tone
detectors may be out-of-service.
1. Resolve any "TTR-LEV" errors.
2. Resolve any "TONE-PT" errors.
3. Retry the command at 1-minute intervals a maximum of 5 times.
The port was seized by a valid call during the test. The test has been
aborted. Use display port PCSSpp to determine the station extension.
Use status station to determine the service state of the port. If the port is in
use, it is unavailable for certain tests. Wait until the port is idle before
testing.
1. Retry the command at 1-minute intervals a maximum of 5 times.
This condition indicates that the test is not applicable when the analog port
is used in a combined modem pool. This error can be ignored.
Test disabled via administration.
1. To enable the test for the particular analog station being tested, enter
change station extension and set the Test field to y.
Continued on next page
555-233-119