Avaya DEFINITY Server CSI Maintenance Manual page 647

ANL-24-L (24-Port Analog Line)
Table 40. TEST #35 Battery Feed Test
Error Test
Code Result
ABORT Could not allocate the necessary system resources to run this test.
1000 ABORT System resources required to run this test are not available. The port may be
busy with a valid call. This result is also reported for the system's
Music-On-Hold port when it is off-hook, which it usually is.
1004 ABORT The port was seized by a valid call during the test. The test has been
aborted.
1005 ABORT The test was aborted due to a configuration problem. This test may not be
applicable, or it may be disruptive to terminal equipment other than a voice
terminal (for example, the modem pool member or Music On Hold).
1018 ABORT The test has been disabled via administration. The default for the
on the station form is y. Determine why this field has been set to
station. It may be due to application Test #48, which can disturb users or
terminal operations.
1392 ABORT This port is currently a TTI port and the test will not execute on it.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT Could not allocate the necessary system resources to run this test.
FAIL The port's battery feed chip is unable to supply sufficient power to the
terminal equipment. This could be a marginal test, and the terminal
equipment may be operating satisfactorily.
555-233-119
Description/Recommendation
1. Retry the command at 1-minute intervals a maximum of 5 times.
1. Use display port PCSSpp to determine the station extension.
2. Use status station to determine the service state of the port.
3. If the port is in use, wait until the port is idle and retry the command at
1-minute intervals a maximum of 5 times.
1. To enable the test for the station being tested, enter change station
extension and set the
1. Verify that the port is a TTI port using display port (the display shows
that the port is a TTI port) or list config (the display shows a t for the
port).
2. If the port is not a TTI port, escalate the problem. If both commands
indicate that the port is a TTI port, the abort is correct for the test, and no
action is necessary.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to fail, determine whether the customer is
experiencing problems on this line. If so, replace the circuit pack.
Test field to y.
Issue 5 October 2002
Test field
n
for this
Continued on next page
647