Avaya DEFINITY Server CSI Maintenance Manual page 1430

Maintenance Objects
Table 376. TEST #36 Audit and Update Test
Error Test
Code Result
ABORT
1000 ABORT
1006 ABORT
2000 ABORT
2100 ABORT
7 or 8 FAIL
1430
Issue 5 October 2002
Description/ Recommendation
Internal System Error.
1. Retry the command at 1-minute intervals a maximum of 5 times.
The test was aborted because system resources required to run this test
were not available. The port may be busy with a valid call. Use the
display port PCSSpp command to determine the station extension of
the port. Use the status station command to determine the service
state of the port. If the service state indicates that the port is in use, then
the port is unavailable for certain tests. You must wait until the port is
idle before retesting.
1. If the port is idle, retry the command at 1-minute intervals a
maximum of 5 times.
The test was aborted because the station is out of service. This
condition may be accompanied by an error type 18 entry in the error log.
You may want to determine why the station was taken out of service.
(When stations are taken out of service by maintenance software, the
problems that preceded that point must be cleared.)
1. Use the status station command to check the service state of the
port. If the port is indeed out of service, enter the release station
command to bring the station back into service.
2. Retry the command at 1-minute intervals a maximum of 5 times.
3. If the test continues to abort, and the service state indicates that the
station is in service and idle, escalate the problem.
The test was aborted because response to the test was not received
within the allowable time period.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
2. If the test aborts with error code 2000 again, run short test
sequence on the associated DS1-BD or UDS1-BD. If tests 138
through 145 on the associated DS1-BD or UDS1-BD are also
aborting with error code 2000, hyperactivity on the board or facility
is indicated. In this case, the hyperactivity problem should be dealt
with first.
System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Test failed due to internal system error. Do not replace port board.
Error code 7: the failure occurred during station translation
download (to DS1 Interface circuit pack).
Error code 8: the failure occurred during station ringer update.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page