Avaya DEFINITY Server CSI Maintenance Manual page 930

Maintenance Objects
Table 163. TEST #6 NPE Crosstalk Test — Continued
Error Test
Code Result
1003 ABORT
1004 ABORT
2000 ABORT
2100 ABORT
Any FAIL
PASS
0 NO
BOARD
930
Issue 5 October 2002
Description/ Recommendation
The system could not allocate a tone receiver for the test. The system may
be oversized for the number of tone detectors present or some tone
detectors may be out-of-service.
1. Look for TTR-LEV errors in the Error Log. If present, refer to TTR-LEV
Maintenance documentation.
2. Look for TONE-PT errors in the Error Log. If present, refer to TONE-PT
Maintenance documentation.
3. If neither condition exists, retry the test at 1-minute intervals a
maximum of 5 times.
The port was seized by a valid call during the test. The test has been
aborted. Use display port PCSSpp to determine the trunk group/member
number of the port. Use status trunk to determine the service state of the
port. If the service state indicates that the port is in use, the port is
unavailable for certain tests. Wait until the port is idle before retesting.
Response to the test request was not received within the allowable time
period.
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
The NPE of the tested port was found to be transmitting in error. This
causes noisy and unreliable connections.
1. Replace the circuit pack.
The port is correctly using its allocated time slots. User-reported troubles on
this port should be investigated by using other port tests and by examining
trunk or external wiring.
The test could not relate the internal ID to the port (no board).
1. Check to ensure that the board translations are correct. Translate the
board, if necessary.
2. Issue busyout board.
3. Issue reset board.
4. Issue release busy board.
5. Issue test board. This should re-establish the linkage between the
internal ID and the port.
Continued on next page
555-233-119