Avaya DEFINITY Server CSI Maintenance Manual page 431

status bri-port
Table 23. Status BRI-Port Command Interpretation — Continued
Endpoint TEI Layer 2
Types Range State
BRI 0-126 Established
BRI, 64-126 Established
ASAI
BRI 64-126 L3-Establish
ed
BRI, 64-126 L3-
ASAI Established
BRI 64-126 L3-
Established
BRI 0-126 L3-
Established
555-233-119
Voice Service
Extension SPID Description / Recommendation
ext blank Normal state for non-MIM initializing,
fixed and automatic TEIBRI endpoints.
blank blank Transitory state for automatic TEIBRI
endpoints which support MIM
initialization.
ext blank Normal state for automatic TEIBRI
endpoints supporting MIM
initialization.
blank yes Technicians conduct SPID facilitation
tests on the port. Links are not
associated with BRI port endpoints.
See description of SPID Facility Test
Procedures in the
ASAI-ADJ, BRI-DAT''
documentation.
ext yes Technicians conduct SPID facilitation
tests on the port. Links are associated
with port endpoints. See description of
SPID Facility Test Procedures in the
''BRI-SET, ASAI-ADJ, BRI-DAT''
maintenance documentation.
blank blank Invalid SPID assigned to link.
1. Verify that SPID administration on
the switch and endpoint are
consistent. Verify the repair by
executing the status bri-port
PCSSpp command. Determine
that the L2 state of the signaling
link is L3-Established. Otherwise,
proceed to Step 2.
2. Try to replace the endpoint. Verify
the repair by executing the status
bri-port PCSSpp command.
Determine that the L2 state of the
signaling link is L3-Established.
''BRI-SET,
maintenance
1. Change the SPID value in the BRI
endpoint to match the SPID
administered to the BRI endpoint
on the port. Verify the repair by
executing the status bri-port
PCSSpp command. Determine
that the L2 state of the BRI
endpoint is L3-Established.
Continued on next page
Issue 5 October 2002
431