Avaya DEFINITY Server CSI Maintenance Manual page 653

ANL-24-L (24-Port Analog Line)
Looparound Test (#161)
This test checks the on-board transmission capabilities of the NPE, the codec,
and the battery feed chip of the analog port. The test passes if the signal
measured by the tone detector is within acceptable limits.
Table 43. TEST #161 Looparound Test
Error Test
Code Result
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1000 ABORT System resources required to run this test are not available. The port may be
busy with a valid call.
1. Use display port PCSSpp to determine the station extension.
2. Use status station to determine the service state of the port.
3. If the port is in use, wait until the port is idle and retry the command at
1002 ABORT The system could not allocate time slots for the test. The system may be under
heavy traffic conditions or it may have time slots out-of-service due to
TDM-BUS errors. Refer to "TDM-BUS" to diagnose TDM-BUS errors.
1. If system has no TDM-BUS errors and is not handling heavy traffic, retry
1003 ABORT The system could not allocate a tone receiver for the test. The system may be
oversized for the number of tone detectors present or some tone detectors
may be out-of-service.
1. Look for TTR-LEV errors in the Error Log. If present, see "TTR-LEV".
2. Look for TONE-PT errors in the Error Log. If present, see "TONE-PT".
3. If neither condition exists, retry the command at 1-minute intervals a
1004 ABORT The port was seized by a valid call during the test. The test has been aborted.
1. Use display port PCSSpp to determine the station extension.
2. Use status station to determine the service state of the port.
3. If the port is in use, wait until the port is idle and retry the command at
1005 ABORT This test is not run on ports administered as External Alert, Announcement or
combined modem pool ports. This error can be ignored.
555-233-119
Description/Recommendation
1-minute intervals a maximum of 5 times.
the command at 1-minute intervals a maximum of 5 times.
maximum of 5 times.
1-minute intervals a maximum of 5 times.
Continued on next page
Issue 5 October 2002
653