Avaya DEFINITY Server CSI Maintenance Manual page 632

Maintenance Objects
Error Log Entries and Test to Clear Values
Error Aux
Type Data
0 (a) 0 Any
1 (c) 40977 None
18 0 busyout station
<extension>
23 (d) 0 None
130 (e) None
257 (f) 40973 None
513 (g) Any None
1025 Loop Around Test
(h) (#161)
1281 Conference Test (#7)
1537 NPE Crosstalk Test (#6)
Notes:
a.
Error Type 0 - Run the Short Test Sequence first. If all tests pass, run the Long Test
Sequence. Refer to the appropriate test description and follow the recommended
procedures.
b.
Minor alarms on this MO may be downgraded to Warnings based on the values in
set options.
c. Error type 1 is an in-line error and can only be resolved over time. This
indicates that no terminal equipment was present when ringing was
attempted. Use the short test port PCSSpp.
d. Error type 23 - The circuit pack has been logically administered but not
physically installed. The alarm will be cleared when the circuit pack is
installed.
e. Error type 130 - The circuit pack has been removed or has been insane for
more than 11 minutes. To clear the error, reseat or replace the circuit pack.
f. Error type 257 is an in-line error and can only be resolved over time. This
error indicates that ringing voltage is absent. If only 1 analog circuit pack in
the system has this problem, replace the circuit pack. If all analog circuit
packs have this error, check the ringing generator.
g. AUDIX is not available to the switch. Check the AUDIX system, referring to
EMBEDDED AUDIX System Maintenance, 585-300-110.
h. The TDM bus is out of service. See the "TDM-BUS" section.
632
Issue 5 October 2002
Associated Test
Any
WRN
WRN
WRN
MIN/
MIN/
MIN/
Alarm On/Off
Level Board
Any test port PCSSpp sh r 1
ON release station extension
OFF
ON test port PCSSpp sh
WRNb ON test port PCSSpp l r 2
WRNb ON test port PCSSpp l r 2
WRNb ON test port PCSSpp l r 2
Test to Clear Value
555-233-119