Avaya DEFINITY Server CSI Maintenance Manual page 660

Maintenance Objects
Table 45. TEST #6 NPE Crosstalk Test
Error Test
Code Result
1000 ABORT
1001 ABORT
1002 ABORT
1003 ABORT
1004 ABORT
660
Issue 5 October 2002
Description/ Recommendation
System resources required to run this test are not available. The port may
be busy with a valid call. Use display port PCSSpp to determine the
station extension. Use status station to determine the service state of the
port. If the service state indicates that the port is in use, the port is
unavailable for certain tests. (Refer to the "Status Commands" section in
Chapter 8, "Maintenance Commands and Trouble-Clearing Aids", for a full
description of all possible states.) Wait until the port is idle before retesting.
1. If the port status is idle, retry the command at 1-minute intervals a
maximum of 5 times.
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
The system could not allocate time slots for the test. The system may be
under heavy traffic conditions or it may have time slots out-of-service due to
TDM-BUS errors. Refer to "TDM-BUS (TDM Bus)" Maintenance
documentation to diagnose any active TDM-BUS errors.
1. If system has no TDM-BUS errors and is not handling heavy traffic,
repeat test at 1-minute intervals a maximum of 5 times.
The system could not allocate a tone receiver for the test. The system may
be oversized for the number of Tone Detectors present or some Tone
Detectors may be out-of-service.
1. Look for TTR-LEV errors in the Error Log. If present, refer to "TTR-LEV
(TTR Level)" Maintenance documentation.
2. Look for TONE-PT errors in the Error Log. If present, refer to
"TONE-PT (Tone Generator)" Maintenance documentation.
3. If neither condition exists, retry the test at 1-minute intervals a
maximum of 5 times.
System resources required to run this test are not available. The port may
be busy with a valid call. Use display port PCSSpp to determine the
station extension. Use status station to determine the service state of the
port. If the service state indicates that the port is in use, the port is
unavailable for certain tests. (Refer to the "Status Commands" section in
Chapter 8, "Maintenance Commands and Trouble-Clearing Aids", for a full
description of all possible states.) Wait until the port is idle before retesting.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page
555-233-119