Test Network-Control - Avaya DEFINITY Server CSI Maintenance Manual

test network-control

test network-control
Use test network-control to run hardware diagnostic tests on a network control
circuit pack.
Action/
Object Qualifier
test location
network-
short
control
long
repeat
number
clear
schedule
1 If no alarms are registered against the maintenance object then the test sequence is run only once. The long
clear option forces a clear of all alarms if no errors are encountered during testing. The short clear option only
clears alarms pertinent to tests in the short sequence. SEE WARNING BELOW
2 See the Report Scheduler and System Printer feature specification for more details.
!
WARNING:
Since the "clear long" options clear all counters if tests pass, it is possible for
firmware counters to be cleared even when a problem exists. In some cases
customer service might degrade since calls may be routed over defective
equipment.
555-233-119
Qualifier Description
Network control board carrier location (a)
Option for a brief series of nondestructive
diagnostic tests.
Option for a longer, more comprehensive
series of both destructive and
nondestructive diagnostic tests.
Number of times each test in the sequence
is repeated (1-100)
This option causes the test sequence
(short or long) to repeat until the alarm (if
any) is cleared or a single test in the
1
sequence fails.
Use the screen to schedule execution of
the command. The command is placed in
the command queue and is executed at the
specified time. The information displayed
by the command is sent to the system
printer instead of the screen.
Examples:
test network-control
test network-control a l
test network-control b sh r 2
test network-control b l r 25
test network-control a
test network-control a c
Logins
init
inads
craft
2
Issue 5 October 2002
Feature
Defaults Interactions
Cabinet 1, none
carrier a,
test
sequence
repeat = 1.
571