Avaya DEFINITY Server CSI Maintenance Manual page 1130

Table 239. TEST #1212 CPE Loopback Jack Test — Continued
Error Test
Code Result
3 FAIL The CPE Loopback Jack Test was not set up properly. The framed 3-in-24
test pattern, generated by the DS1 Interface circuit pack and looped back
through the CPE Loopback Jack, could not be detected properly by the DS1
circuit pack.
PASS The CPE Loopback Jack test has successfully began executing. The test will
continue to run until the system technician enters the test ds1-loop UUCSS
end-loopback/span-test command or the release board UUCSS command.
0 NO The test could not relate the internal ID to the port (no board).
BOARD
This could be due to incorrect translations, no board is inserted, an incorrect
board is inserted, or an insane board is inserted.
This should re-establish the link between the internal ID and the port.
1130
Issue 5 October 2002
Description/ Recommendation
1. Retry test ds1-loop UUCSS cpe-loopback-jack-test-begin.
2. If the CPE Loopback test continues to fail, the problem could be with the
TN767E board, the CPE Loopback Jack equipment, or somewhere in
between. Run test ds1-loop UUCSS ds1/csu-loopback-tests to see if
the loopback tests closer to the TN767E board are successful. If any of
those loopback tests fail, follow the maintenance strategy associated with
those loopbacks.
1. Check to ensure that the board translations are correct. Use the add ds1
UUCSS command to administer the DS1 interface if it is not already
administered.
2. If board was already administered correctly, check the error log to
determine if the board is hyperactive. If this is the case, the board is shut
down. Reseating the board will re-initialize the board.
3. If the board was found to be correctly inserted in step 1, issue the
busyout board command.
4. Issue the reset board command.
5. Issue the release busy board command.
6. Issue the test board long command.
Continued on next page
555-233-119