ipv6 pimsm spt-threshold
Use the ipv6 pimsm spt-threshold command to configure the Data Threshold rate for the last-
hop router to switch to the shortest path. Use the "no" form of this command to set the data
threshold to the default.
Syntax
ipv6 pimsm spt-threshold
no ipv6 pimsm spt-threshold
threshold — The threshold rate (Range: 0–2000 Kbps).
•
Default Configuration
The default threshold rate is 0.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pimsm spt-threshold 1000
ipv6 pimsm ssm
Use the ipv6 pimsm ssm command to define the Source Specific Multicast (SSM) range of
multicast addresses.
Syntax
ipv6 pimsm ssm { default | group-address/prefixlength }
•
default— Defines the SSM range access list to 232/8.
•
group-address— Group IP address supported by RP.
•
prefixlength— This parameter specifies the prefix length of the IP address for the media
gateway. (Range: 1–32)
Default Configuration
There is no SSM range defined by default.
648
IPv6 Multicast Commands
threshold