Storm-Control Multicast - Dell PowerConnect 8024 Cli Reference Manual

no storm-control broadcast
rate — Percentage of port bandwidth to allow. (Range: 0-100)
•
Default Configuration
The default value is 5.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
console(config-if-1/g1)#storm-control broadcast level 5

storm-control multicast

Use the storm-control multicast command in Interface Configuration mode to enable multicast
storm recovery mode for an interface. If the mode is enabled, multicast storm recovery is active,
and if the rate of L2 multicast traffic ingressing on an interface increases beyond the configured
threshold, the traffic will be dropped. Therefore, the rate of multicast traffic will be limited to
the configured threshold.
Syntax
storm-control multicast [level
no storm-control multicast
rate — Maximum packets per second of multicast traffic on a port. (Range: 0-100)
•
Default Configuration
The default value is 5.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
264
Ethernet Configuration Commands
rate
]