Ping Ipv6 - Dell PowerConnect 8024 Cli Reference Manual

Default Configuration
Disabled is the default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example globally enables Ipv6 unicast datagram forwarding.
console(config)#ipv6 unicast-routing
console(config)#no ipv6 unicast-routing

ping ipv6

Use ping ipv6 command in Privileged EXEC mode to determine whether another computer is
on the network. To use the command, configure the switch for network (in-band) connection.
The source and target devices must have the ping utility enabled and running on top of TCP/IP .
The switch can be pinged from any IP workstation with which the switch is connected through
the default VLAN (VLAN 1), as long as there is a physical path between the switch and the
workstation. The terminal interface sends three pings to the target station.
Syntax
ping ipv6 {
ipv6-address — Target IPv6 address to ping.
•
hostname — Hostname to ping (contact). (Range: 1–158 characters)
•
size — Size of the datagram. (Range: 48–2048 bytes)
•
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
676
IPv6 Routing Commands
ip-address hostname
|
size
} [size ]