Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the number of paths that OSPF can report for a destination to 1.
console(config)#ipv6 router ospf
console(config-rtr)#maximum-paths 1
passive-interface
Use the passive-interface command to set the interface or tunnel as passive. It overrides the
global passive mode that is currently effective on the interface or tunnel. Use the "no" form of
this command to set the interface or tunnel as non-passive.
Syntax
passive-interface {vlan
no passive-interface {vlan
vlan-id — The vlan number
•
tunnel-id — Tunnel identifier. (Range: 0–7)
•
Default Configuration
Passive interface mode is disabled by default.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-router)#passive-interface vlan 1
808
OSPFv3 Commands
vlan-id
tunnel-id
| tunnel
vlan-id
tunnel-id
| tunnel
}
}