Lldp Transmit - Dell PowerConnect 8024 Cli Reference Manual

Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Examples
The following example displays how to configure LLDP to transmit local information every
1000 seconds.
console(config)#lldp timers interval 1000
The following example displays how to set the timing parameter at 1000 seconds with a hold
multiplier of 8 and a 5 second delay before re-initialization.
console(config)#lldp timers interval 1000 hold 8 reinit 5

lldp transmit

Use the lldp transmit command in Interface Configuration mode to enable the LLDP advertise
(transmit) capability. To disable local data transmission, use the no form of this command.
Syntax
lldp transmit
no lldp transmit
Default Configuration
LLDP is disabled on all supported interfaces.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how enable the transmission of local data.
console(config-if-1/g3)#lldp transmit
358
LLDP Commands