Interface
IP Address
---------- ----------
vlan1
0.0.0.0
vlan2
0.0.0.0
split-horizon
Use the split-horizon command in Router RIP Configuration mode to set the RIP split horizon
mode. Use the no form of the command to return the mode to the default value.
Syntax
split-horizon {none | simple | poison}
no split-horizon
•
none — RIP does not use split horizon to avoid routing loops.
•
simple — RIP uses split horizon to avoid routing loops.
•
poison — RIP uses split horizon with poison reverse (increases routing packet update size).
Default Configuration
Simple is the default configuration.
Command Mode
Router RIP Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example does not use split horizon.
console(config-router)#split-horizon none
Send
Receive
Version
Version
-------- ----------- --------- ----------
RIP-2
Both
RIP-2
Both
Routing Information Protocol Commands
RIP
Link
Mode
State
Disable
Down
Disable
Down
857