Sflow Polling - Dell PowerConnect 8024 Cli Reference Manual

before trying to claim it. The entry is claimed by setting the owner string to a non-null value.
The entry must be claimed before assigning a receiver to a sampler or poller. (Range: 1–127
characters).
rcvr_timeout —The time, in seconds, remaining before the sampler or poller is released and
•
stops sending samples to the receiver. A management entity wanting to maintain control of
the sampler is responsible for setting a new value before the old one expires. (Range:
0–4294967295 seconds).
port — The destination Layer4 UDP port for sFlow datagrams. (Range: 1–65535).
•
Default Configuration
No receivers are configured by default.
The default IP address is 0.0.0.0
The default maximum datagram size is 1400.
The default owner string is the empty string.
The default receiver timeout is 0.
The default port is 6343.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines
Example
console(config)#sflow 1 destination owner 1 timeout 2000
console(config)#sflow 1 destination maxdatagram 500
console(config)#sflow 1 destination 30.30.30.1 560

sflow polling

Use the sflow polling command to enable a new sflow poller instance for this data source if
rcvr_idx is valid. Use the "no" form of this command to reset poller parameters to the defaults.
Syntax
rcvr-index
sflow
1010
Sflow Commands
interfaces poll-interval
polling ethernet