speed
Use the speed command in Interface Configuration mode to configure the speed of a given
Ethernet interface when not using auto-negotiation. To restore the default, use the no form of
this command.
Syntax
speed [10 | 100 ]
no speed
•
10 — Configures the port to 10 Mbps operation.
•
100 — Configures the port to 100 Mbps operation.
Default Configuration
This command has no default setting.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
NOTE: This command is unsupported on PC8024/PC8024F 10G Base T ports.
Example
The following example configures the speed operation of Ethernet port 1/xgn to force 100-Mbps
operation.
console(config)#interface ethernet 1/xgn
console(config-if-1/xgn)#speed 100
storm-control broadcast
Use the storm-control broadcast command in Interface Configuration mode to enable
broadcast storm recovery mode for a specific interface. If the mode is enabled, broadcast storm
recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface increases
beyond the configured threshold, the traffic will be dropped. Therefore, the rate of broadcast
traffic will be limited to the configured threshold.
Syntax
storm-control broadcast [level
rate
]
Ethernet Configuration Commands
263