Show Ipv6 Route Preferences - Dell PowerConnect 8024 Cli Reference Manual

ipv6-address — Specifies an IPv6 address for which the best-matching route would be
•
displayed.
protocol — Specifies the protocol that installed the routes. Is one of the following keywords:
•
connected, ospf, static.
ipv6-prefix/ipv6 prefix-length — Specifies a IPv6 network for which the matching route would
•
be displayed.
interface — Valid IPv6 interface. Specifies that the routes with next-hops on the selected
•
interface be displayed.
• all — Specifies that all routes including best and non-best routes are displayed. Otherwise,
only the best routes are displayed. If the connected keyword is selected for protocol, the all
option is not available because there are no best or non-best connected routes.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the IPv6 routing table.
console(config)#show ipv6 route
IPv6 Routing Table - 0 entries
Codes: C - connected, S - static
O - OSPF Intra, OI - OSPF Inter, OE1 - OSPF Ext 1, OE2 - OSPF Ext 2
ON1 - OSPF NSSA Ext Type 1, ON2 - OSPF NSSA Ext Type 2

show ipv6 route preferences

Use the show ipv6 route preferences command in Privileged EXEC mode to show the
preference value associated with the type of route. Lower numbers have a greater preference.
Syntax
show ipv6 route preferences
696
IPv6 Routing Commands