Ip Igmp Snooping Querier Query-Interval; Ip Igmp Snooping Querier Timer Expiry - Dell PowerConnect 8024 Cli Reference Manual

Example
The following example configures the snooping querier to participate in the querier election.
console(config-vlan)#ip igmp snooping querier election participate

ip igmp snooping querier query-interval

This command sets the IGMP Querier Query Interval time, which is the amount of time in
seconds that the switch waits before sending another periodic query. The no form of this
command sets the IGMP Querier Query Interval time to its default value.
Syntax
ip igmp snooping querier query-interval
no ip igmp snooping querier query-interval
seconds — Amount of time in seconds that the switch waits before sending another general
•
query. (Range: 1-1800)
Default Configuration
The query interval default is 60 seconds.
Command Mode
Global Configuration mode
User Guidelines
The value of this parameter should be larger than the IGMP Snooping Max Response Time.
Example
The following example sets the query interval to 1800:
ip igmp snooping querier query_interval 1800

ip igmp snooping querier timer expiry

This command sets the IGMP Querier timer expiration period which is the time period that the
switch remains in Non-Querier mode after it has discovered that there is a Multicast Querier in
the network. The no form of this command sets the IGMP Querier timer expiration period to its
default value.
Syntax
ip igmp snooping querier timer expiry
no ip igmp snooping querier timer expiry
seconds
seconds
IGMP Snooping Querier Commands
291