Snmp-Server Contact; Snmp-Server Enable Traps - Dell PowerConnect 8024 Cli Reference Manual

snmp-server contact

Use the snmp-server contact command in Global Configuration mode to set up a system
contact (sysContact) string. To remove the system contact information, use the no form of the
command.
Syntax
snmp-server contact
no snmp-server contact
text — Character string, 0 to 160 characters, describing the system contact information.
•
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays setting up the system contact point as
"Dell_Technical_Support".
console(config)# snmp-server contact Dell_Technical_Support

snmp-server enable traps

Use the snmp-server enable traps command to enable SNMP traps globally or to enable specific
SNMP traps. Use the "no" form of this command to disable SNMP traps. See Granular OSPF
v2/v3 Traps for more detail about the OSPF trap types.
Syntax
snmp-server enable traps [ acl | all | authentication | captive portal | dvmrp | link | multiple
users | ospf
ospftype - {
•
1030
SNMP Commands
text
ospftype ospfv3type
| ospfv3
all |
errors { all | authentication failure | bad packet | config error | virt authentication
failure | virt bad packet | virt config error } | lsa { all | lsa-maxage | lsa-originate } |
overflow { all| lsdb-overflow | lsdb-approaching-overflow } | retransmit {all |packets|
| pim | spanning tree ]