Ipv6 Traffic-Filter - Dell PowerConnect 8024 Cli Reference Manual

name — the name of an existing IPv6 ACL.
•
newname — alphanumeric string from 1 to 31 characters uniquely identifying the IPv6 access
•
list.
Default Configuration
There is no default configuration for this command.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(Config)#ipv6 access-list rename DELL_IP6 DELL_IP6_NEW_NAME

ipv6 traffic-filter

The ipv6 traffic-filter command either attaches a specific IPv6 Access Control List (ACL) to an
interface or associates it with a VLAN ID in a given direction.
An optional sequence number may be specified to indicate the order of this access list relative to
other IPv6 access lists already assigned to this interface and direction. A lower number indicates
higher precedence order. If a sequence number is already in use for this interface and direction,
the specified IPv6 access list replaces the currently attached IPv6 access list using that sequence
number. If the sequence number is not specified for this command, a sequence number that is
one greater than the highest sequence number currently in use for this interface and direction is
used.
Use the "no" form of the command to remove an IPv6 ACL from the interface(s) in a given
direction.
Syntax
ipv6 traffic-filter
no ipv6 traffic-filter
• name — Alphanumeric string of 1 to 31 characters uniquely identifying the IPv6 access list.
direction — Direction of the ACL. (Range: in or out)
•
• sequence
interface and direction. (Range: 1–4294967295)
312
IPv6 Access List Commands
name direction
[sequence
name direction
seq-num — Order of access list relative to other access lists already assigned to this
seq-num
]