Example
The following example adds a description to the Ethernet port 5.
console(config)#interface ethernet 1/g5
console(config-if-1/g5)# description RD_SW#3
duplex
Use the duplex command in Interface Configuration mode to configure the full/half duplex
operation of a given Ethernet interface when not using auto-negotiation. To restore the default,
use the no form of this command.
Syntax
duplex {half | full}
no duplex
•
half — Force half-duplex operation
•
full — Force full-duplex operation
Default Configuration
The interface is set to full duplex.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the duplex operation of Ethernet port 5 to force full duplex
operation.
console(config)# interface ethernet 1/g5
console(config-if-1/g5)# duplex full
flowcontrol
Use the flowcontrol command in Global Configuration mode to configure the flow control. To
disable flow control, use the no form of this command.
Ethernet Configuration Commands
237