Snmp-Server V3-Host - Dell PowerConnect 8024 Cli Reference Manual

snmp-server v3-host

Use the snmp-server v3-host command in Global Configuration mode to specify the recipient of
Simple Network Management Protocol Version 3 notifications. To remove the specified host,
use the no form of this command.
Syntax
snmp-server v3-host {
priv] [timeout
no snmp-server host
ip-address — Specifies the IP address of the host (targeted recipient).
•
hostname — Specifies the name of the host. (Range: 1-158 characters.)
•
username — Specifies user name used to generate the notification. (Range: 1-25 characters.)
•
traps — Indicates that SNMP traps are sent to this host.
•
• informs — Indicates that SNMPv2 informs are sent to this host.
• noauth — Specifies sending of a packet without authentication.
• auth — Specifies authentication of a packet without encrypting it
• priv — Specifies authentication and encryption of a packet.
seconds — Number of seconds to wait for an acknowledgment before resending informs. This
•
is not allowed for hosts configured to send traps. The default is 15 seconds. (Range: 1-300
seconds.)
retries — Maximum number of times to resend an inform request. This is not allowed for
•
hosts configured to send traps. The default is 3 attempts. (Range: 0-255 retries.)
port — UDP port of the host to use. The default is 162. (Range: 1-65535.)
•
filtername — A string that is the name of the filter that define the filter for this host. If
•
unspecified, does not filter anything. (Range: 1-30 characters.)
Default Configuration
Default configuration is 3 retries and 15 seconds timeout.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
1040
SNMP Commands
ip-address hostname
|
seconds retries
] [retries
ip-address
username
} {traps | informs} [noauth | auth |
port
] [udpport ] [filter
filtername
]