Show Igmp Snooping Querier - Dell PowerConnect 8024 Cli Reference Manual

show igmp snooping querier

This command displays IGMP Snooping Querier information. Configured information is
displayed whether or not IGMP Snooping Querier is enabled.
When the optional argument
information:
• Admin Mode — Indicates whether or not IGMP Snooping Querier is active on the switch.
• Admin Version — Indicates the version of IGMP that will be used while sending out the
queries.
• Source IP Address — Shows the IP address that is used in the IPv4 header when sending out
IGMP queries. It can be configured using the appropriate command.
• Query Interval — Shows the amount of time in seconds that a Snooping Querier waits before
sending out the periodic general query
• Querier Timeout — Displays the amount of time to wait in the Non-Querier operational
state before moving to a Querier state.
When you specify a value for
• VLAN Admin Mode — Indicates whether IGMP Snooping Querier is active on the VLAN.
• VLAN Operational State — Indicates whether IGMP Snooping Querier is in the Querier or
Non-Querier state. When the switch is in Querier state it sends out periodic general queries.
When in Non-Querier state it waits for moving to Querier state and does not send out any
queries.
• VLAN Operational Max Response Time — Indicates the time to wait before removing a
Leave from a host upon receiving a Leave request. This value is calculated dynamically from
the Queries received from the network. If the Snooping Switch is in Querier state, then it is
equal to the configured value.
• Querier Election Participate — Indicates whether the IGMP Snooping Querier participates in
querier election if it discovers the presence of a querier in the VLAN.
• Last Querier Address — Indicates the IP address of the most recent Querier from which a
Query was received.
• Last Querier Version — Indicates the IGMP version of the most recent Querier from which a
Query was received on this VLAN.
• Elected Querier — Indicates the IP address of the Querier that has been designated as the
Querier based on its source IP address. This field will be 0.0.0.0 when Querier Election
Participate mode is disabled
When the optional argument detail is used, the command shows the global information and the
information for all Querier enabled VLANs.
vlan_id
is not used, the command shows the following
vlan_id
, the following information appears:
IGMP Snooping Querier Commands
293