Ip Address - Dell PowerConnect 8024 Cli Reference Manual

Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example deletes all entries from the host name-to-address cache.
console#clear host *

ip address

Use the ip address command in Global Configuration mode to set an IP address. To remove an
IP address, use the no form of this command.
Syntax
ip address {bootp|dhcp|none|
no ip address
• bootp--Sets protocol to bootp
• dhcp--Sets protocol to dhcp
• none--No protocol is set
• ipaddress — Specifies a valid IP address.
mask — Specifies a valid subnet (network) mask IP address.
•
prefix-length — The number of bits that comprise the IP address prefix. The prefix length
•
must be preceded by a forward slash (/). (Range: 1-30)
Default Configuration
The switch management interface is unconfigured by default.
Command Mode
Global Configuration mode
User Guidelines
DHCP cannot be enabled on the management interface and the out-of-band interface at the
same time.
296
IP Addressing Commands
<ipaddress> mask prefix-length
{ | }}