Ipv6 Forwarding; Ipv6 Enable - Dell PowerConnect 8024 Cli Reference Manual

console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 address 2020:1::1/64

ipv6 enable

Use the ipv6 enable command in Interface Configuration mode to enable IPv6 routing on an
interface (including tunnel and loopback interfaces) that has not been configured with an
explicit IPv6 address. Command execution automatically configures the interface with a link-
local address. The command is not required if an IPv6 global address is configured on the
interface.
Syntax
ipv6 enable
no ipv6 enable
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables IPv6 routing, which has not been configured with an explicit
IPv6 address.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 enable

ipv6 forwarding

Use the ipv6 forwarding command in Global Configuration mode to enable IPv6 forwarding on
a router.
Syntax
ipv6 forwarding
no ipv6 forwarding
659
IPv6 Routing Commands