Member - Dell PowerConnect 8024 Cli Reference Manual

console#show interfaces configuration ethernet 1/xg1
Port Type
----- ------------ ------- ------- ----
1/xg1 10G - Level

member

Use the member command in Stack Global Configuration mode to configure the switch.
Execute this command on the Management Switch. To remove a switch from the stack, use the
no form of the command.
NOTE: The "no" form of the command may not be used if the member is present in the stack.
Syntax
unit switchindex
member
unit
no member
unit — The switch identifier of the switch to be added or removed from the stack. (Range:
•
1–12)
switchindex — The index into the database of the supported switch types, indicating the type
•
of the switch being preconfigured. The switch index is a 32-bit integer.
Default configuration
This command has no defaults.
Command Mode
Stack Global Configuration
User Guidelines
The switch index can be obtained by executing the show supported switchtype command in
User Exec mode.
Example
The following example displays how to add to stack switch number 2 with index 1.
console(config)# stack
console(config-stack)# member 2 1
Duplex Speed Neg
N/A Unknown Auto
MDIX Admin Mode
---- ----------
Auto low-power
System Management Commands
1073