If The Operational Check Fails - HP 86060C Series User Manual

Installing

If The Operational Check Fails

If The Operational Check Fails

If the HP 86060C does not pass the operational check, you should review the
procedure being performed when the problem occurred. A few minutes spent
performing some simple checks may save waiting for your instrument to be
repaired. Before calling Hewlett-Packard or returning the unit for service,
please make the following checks:
1 Is the line fuse good?
2 Does the line socket have power?
3 Is the unit plugged in to the proper ac power source?
4 Is the unit turned on?
5 If other equipment, cables, and connectors are being used with the lightwave
switch, are they connected properly and operating correctly?
6 Review the procedure for the test being performed when the problem
appeared. Are all the settings correct?
7 Are the connectors clean? Refer to "Care of Fiber-Optic Connectors" on page
1-13 for more information about cleaning the connectors.
Refer to "Spare Channel Replacement Procedure" on page 5-4 for more infor-
mation.
If the HP 86060C lightwave switch still fails, return it to Hewlett-Packard for
repair; if the lightwave switch is still under warranty or is covered by an
HP maintenance contract, it will be repaired under the terms of the warranty
or contract (the warranty is at the front of this manual). If the lightwave
switch is no longer under warranty or is not covered by an HP maintenance
plan, Hewlett-Packard will notify you of the cost of the repair after examining
the unit. Refer to "Returning the Instrument for Service" on page 1-20 for
more information.
2-10