Display Mpls Route-State - HP 5800 series Command Reference Manual

• regular-expression: Specifies a regular expression, which is a case-sensitive string of 1 to 256
characters.
Examples
# Display the usage information of the specified NHLFE entry.
<Sysname> display mpls nhlfe reflist 11
No. Type
-------------------------------------------------------------
1 ILM
2 FTN
3 LPW
4 VPW
5 FRR
Table 37 Command output
Field
Total interface node
Type
Key-Info
NOTE:
An asterisk (*) before the number of a node entry means that the node is invalid and is to be deleted.
Table 38 Types of associated nodes and their key parameters
Node type
FTN
ILM
LPW
VPW
FRR
BFD

display mpls route-state

Description
Use the display mpls route-state command to display the LSP information of routes.
With no VPN instance specified, the command displays the LSP information of the routes of the public
network instance.
Key-Info
1023(Inlabel)
1(VPN ID)
----(SRV ID)
1(VSI ID)
11(Token)
Description
Total number of associated nodes
Type of the associated node
Key parameters of the entry
Description
FEC to NHLFE mapping
Incoming label mapping
Sending entries of VPWS PW
Sending entries of VPLS PW
Primary NHLFE of FRR
Check the connectivity of the NHLFE
through BFD
79
Vlan10(In-If)
2.2.2.2/32
Vlan20(Private-If)
1(Link ID)
----
Key parameter
•
VPN ID: VPN instance ID
•
Address prefix/mask
•
In-Label: Incoming label
•
In-If: Incoming interface
•
SRV ID: Service instance ID
•
Private-If: Private network interface
•
VSI ID: Virtual switching instance
ID
•
Link ID: Link ID
Token: Token of the primary NHLFE
BFD Discr: Local discriminator value of
the BFD session