Configuring RIPng basic functions
This section presents the information to configure the basic RIPng features.
You must enable RIPng first before configuring other tasks, but it is not necessary for RIPng-related
interface configurations, such as assigning an IPv6 address.
Configuration prerequisites
Before configuring RIPng basic functions, complete the following tasks:
•
Enable IPv6 packet forwarding.
Configure an IP address for each interface, and ensure all nodes are reachable to one another.
•
Configuration procedure
Follow these steps to configure the basic RIPng functions:
To do...
Enter system view
Create a RIPng process and enter
RIPng view
Return to system view
Enter interface view
Enable RIPng on the interface
NOTE:
If RIPng is not enabled on an interface, the interface will not send or receive a RIPng route.
Configuring RIPng route control
This section covers the following topics:
Configuring RIPng route summarization
•
Advertising a default route
•
Configuring a RIPng route filtering policy
•
•
Configuring a priority for RIPng
Configuring RIPng route redistribution
•
Before configuring RIPng, complete the following tasks:
Configure an IPv6 address on each interface, and ensure all nodes are reachable to one another.
•
•
Configure RIPng basic functions
Define an IPv6 ACL before using it for route filtering. See ACL and QoS Configuration Guide for
•
related information.
Use the command...
system-view
ripng [ process-id ]
quit
interface interface-type
interface-number
ripng process-id enable
266
Remarks
––
Required
Not created by default
—
––
Required
Disabled by default