Table of Contents
Advertisement
MAC address table changes
MAC Address Count
Address
---------------- ----------- ------- ------ ------ -------
15.146.194.77
15.255.134.252
16.181.49.167
16.181.51.14
Excluded MIBs
1
The notify option is enabled.
Advanced management: RMON
The switch supports RMON (remote monitoring) on all connected network segments. This allows for
troubleshooting and optimizing your network.
The following RMON groups are supported:
•
Ethernet Statistics (except the numbers of packets of different frame sizes)
•
Alarm
•
History (of the supported Ethernet statistics)
•
Event
The RMON agent automatically runs in the switch. Use the RMON management station on your network to
enable or disable specific RMON traps and events. Note that you can access the Ethernet statistics, Alarm and
Event groups from the Switch Manager network management software.
CLI-configured sFlow with multiple instances
sFlow can also be configured via the CLI for up to three distinct sFlow instances: once enabled, an sFlow
receiver/destination can be independently configured for full flow-sampling and counter-polling. CLI-configured
sFlow instances may be saved to the startup configuration to persist across a switch reboot.
Configuring sFlow (CLI)
The following sFlow commands allow you to configure sFlow instances via the CLI. For more information, see
Advanced management: RMON on page 213.
Syntax:
[no] sflow <receiver-instance> destination <ip-address> [< udp-port-num >]
Enables an sFlow receiver/destination. The receiver-instance number must be a 1, 2, or 3.
By default, the udp destination port number is 6343.
To disable an sFlow receiver/destination, enter no sflow receiver-instance .
Syntax:
sflow <receiver-instance> sampling <port-list> <sampling rate>
Chapter 7 Configuring for Network Management Applications
: Disabled
: Enabled
Community
Events
public
None
public
None
public
None
public
None
1
Type
Retry
Timeout
trap
3
15
trap
3
15
trap
3
15
trap
3
15
213
Advertisement
Table of Contents
Troubleshooting
