Initializing Parameters - Agilent Technologies ENA Series User Manual

Setting Measurement Conditions

Initializing Parameters

Initializing Parameters
The E5070/E5071A has three different initial settings as shown in Table 3-1 below.
Table 3-1 E5070/E5071A Initial Settings and Methods for Restoring Them
Initial setting
Preset state
*RST state
Factory default setting
For further details of each setting, refer to Appendix C, "List of Default Values," on
page 391. To restore initial settings using commands, refer to the Programmer's Guide and
VBA Programmer's Guide.
52
Restore Method
• Press - on the front panel
OK
or,
• Execute SCPI commands :SYST:PRES.
Execute the *RST command.
(The way the E5070/E5071A is set up prior to
shipment from the factory)
Chapter 3