Sweep Function - Agilent Technologies ENA Series User Manual

Table F-2 Test Port Output Power Levels
Function
Output power levels
Output power ranges

Sweep Function

The list(segment) sweep function enables you to perform measurements corresponding to
two or more sweep conditions in one sweep operation and is supported both on the 8753ES
and E5070A/E5071A. While the 8753ES allows only up to 30 segments per table to be
defined, the E5070A/E5071A allows up to 201 segments to be defined. Furthermore, while
two or more commands are needed to create a table using GPIB (SCPI) commands on the
8753ES, only one command does the same function on the E5070A/E5071A.
The 8753ES supports an IF bandwidth up to 6 kHz, but the E5070A/E5071Asupports an IF
bandwidth up to 100 kHz, enabling faster sweep operations than with the 8753ES.
While the power sweep function is supported on the 8753ES, it is not supported on the
E5070A/E5071A. Furthermore, while the 8753ES supports automatically selecting the
output power range, the E5070A/E5071A supports only manual selection.
On the 8753ES, which supports frequency offset sweeps, frequency conversion devices
such as mixers can be measured. The E5070A/E5071A, however, does not support this
function.
Appendix F
Replacing the 8753ES with the E5070A/E5071A
Important Functional Differences
8753ES
-85 dBm to 10 dBm (std.)
-85 dBm to 8 dBm
(Options 014 and 075)
-15 dBm to 10 dBm (std.) or
-15 dBm to 8 dBm
(Options 014 and 075),
-25 dBm to 0 dBm,
-35 dBm to -10 dBm,
-45 dBm to -20 dBm,
-55 dBm to -30 dBm,
-65 dBm to -40 dBm,
-75 dBm to -50 dBm,
-85 dBm to -60 dBm
E5070A/E5071A
-15 dBm to 0 dBm
(Options 213, 313, and 413)
-50 dBm to 0 dBm
(Options 214, 314, and 414)
-15 dBm to 0 dBm only
(Options 213, 313, and 413)
-15 dBm to 0 dBm,
-20 dBm to -5 dBm,
-25 dBm to -10 dBm,
-30 dBm to -15 dBm,
-35 dBm to -20 dBm,
-45 dBm to -30 dBm,
-50 dBm to -35 dBm
(Options 214, 314, and 414)
461