Evaluating transmission characteristics of a front end module
Step 2. Set the trigger source to "manual."
Description of setting
Set the trigger source to "manual."
Step 3. Set the trigger mode for channel 1 to "continuous."
Description of setting
Set channel 1 to the active channel.
Set the trigger mode to "continuous."
Step 4. Set the trigger mode for channels 2, 3, and 4 to "continuous" according to the same
procedure as in Step 3.
Step 5. Execute the measurement.
Description of setting
Generate a trigger event.
Step 6. Repeat the following procedure to execute the auto scale for all the channels.
Description of setting
Set the active channel.
Execute the auto scale.
Step 7. After all the procedures are complete, the screen as shown in Figure 14-38 appears.
Chapter 14
Measurement Examples
Key stroke
-
Trigger Source
Manual
Key stroke
Continuous
Key stroke
Trigger
Key stroke
- Auto Scale
325