Agilent Technologies ENA Series User Manual page 51

5-8. Calibration Properties
Displays the status of the calibration between test ports on a channel in a matrix format.
Figure 2-7 Calibration Properties Display
5-9. Channel Status Bar
The status of each channel is displayed here. (See parts 5-10 through 5-16.)
5-10. Channel Measurement Status
Displays the update status of traces on the channel.
!
#
(No display)
5-11. Error Calibration Status
Displays the execution status of error correction on the channel.
Cor
Cor
Off
(displayed in gray)
---
C?
(displayed in blue)
C!
Chapter 2
Measurement in progress. When the sweep time exceeds
1.5 seconds,
Invalid traces. The measurement conditions have changed,
but the traces on the channel currently displayed have not
been updated to match the new conditions.
The measurement has not executed.
(displayed in blue) Error correction: ON (valid for all traces)
(displayed in gray) Error correction: ON (valid for parts of traces)
(displayed in gray) Error correction: OFF
Error correction: ON (calibration data not available)
(displayed in blue) Error correction: ON (An interpolation process is in
progress, or one or more among the IF bandwidth, the
power level, the power range, the sweep time, the sweep
delay, the sweep mode (step/swept), the sweep type
(linear/segment) does not match that of the calibration.)
Error correction: ON (An extrapolation process is in
progress)
Overview of Functions
Screen Area: Names and Functions of Parts
­ is displayed at the point on the trace.
43