Create A Segment Sweep Table - Agilent Technologies ENA Series User Manual

Measurement Examples
Evaluating a Duplexer

2. Create a Segment Sweep Table

Entries are made into the segment sweep table following the steps described below.
Step 1. Display the segment table.
Setup Description
Presetting
Displaying the segment table
Step 2. Enter the setup data into the segment table.
NOTE In this step, the IF Bandwidth, power level, delay time, and sweep time are not entered
segment by segment. By turning off the display of those parameters on the segment table,
you can use, in each segment without making a change, the IF Bandwidth (preset value: 70
kHz) of the channel specified by using
dBm) of the channel specified by using
value: 0 second) of the channel specified by using
mode (preset value: Stepped mode) of the channel specified by using
Sweep Mode
Setup Description
Segment 1
Segment 2
Segment 3
Segment 4
288
; and Sweep time (preset value: Automatic) of the channel specified by using
- .
Sweep Time
Start frequency: 1.73 GHz
Stop frequency: 1.83 GHz
Number of points: 50
Start frequency: 1.83 GHz
Stop frequency: 2.03 GHz
Number of points: 400
Start frequency: 2.03 GHz
Stop frequency: 2.13 GHz
Number of points: 50
Start frequency: 3.65 GHz
Stop frequency: 4.03 GHz
Key Operation
-
OK
-
Edit Segment Table
- ; Power level (preset value: 0
IF Bandwidth
- ; Sweep delay time (preset
Power
-
Sweep Delay
Key Operation
; Sweep
-
Chapter 14