Agilent Technologies ENA Series User Manual page 480

Replacing the 8753ES with the E5070A/E5071A
Comparing Functions
Table F-5 Functions of the 8753ES vs. the E5070A/E5071A
Function
Calibration Calibration kit
Calibration
type
Omission of the isolation measurement
Velocity factor
Characteristic impedance of the measurement
system
Port extensionr
Adapter removal
Selection between chop sweep and alternate
sweep
Error correction
Interpolating the calibration coefficient
472
Not more than two ports
Not less than three ports
8753ES
Available calibration kits:
7 mm: 85031B
3.5 mm: 85033C/D/E
N type (50 W): 85032B/E/F
N type (75 W): 85036B/E
2.4 mm: 85056A/D
TRL 3.5 mm: 85052C
User defined calibration kit
Response calibration
Response and isolation calibration
Enhanced response calibration
S11 1-port calibration
S22 1-port calibration
Full 2-port calibration
TRL*/LRM* Calibration
Receiver calibration
Power meter calibration
Not available
Possible
(Can be omitted by designating it
using the softkeys on the front panel
or sending a GPIB command from
the front panel)
Definable
Definable
Definable for ports 1 and 2 and
inputs A and B
Available
Can be changed over.
On/Off setting is definable.
On/Off setting is definable.
E5070A/E5071A
3.5 mm:85033D/E, 85052D
N type (50 W): 85032B/F
Up to six user defined calibration
kits can be registered.
Response calibration
(OPEN,SHORT, THRU)
Full 1-port calibration
Full 2-port calibration
TRL*/LRM* Calibration (VBA)
The response calibration includes
isolation measurement as an option.
Full 3-port calibration (Opts. 313,
314, 413, and 414 only)
Full 4-port calibration(Opts. 413 and
414 only)
Possible
(Isolation measurement is performed
as an option accompanying a
response calibration and 2-, 3-, and
4-port calibration.)
¬
Definable with fixture simulator
Definable for each port per channel
Not available
Chop sweep for traces in a channel
and alternate sweep between
channels
¬
Always On.
Appendix F