Figure 6-7
Target Search (when transition type is set to "both positive and negative")
Executing a Target Search
Step 1. Following Step 1 to Step 4 in "Reading Values on the Trace" on page 128, activate the
marker you are using for the target search.
Step 2. Press
Step 3. Press
This causes the target search to be executed based on the definitions of the currently set
target value and transition type.
Step 4. Press
This causes the target search to be executed based on the definitions of the currently set
target value and transition type.
Step 5. Press
Step 6. Select a transition type.
Softkey
Positive
Negative
Both
This causes the target search to be executed based on the definitions of the currently set
target value and transition type.
Step 7. Press the corresponding softkey to move the marker to the target.
Softkey
Search Target
Search Left
Chapter 6
.
.
Target
, and enter the target value in the entry area that appears.
Target Value
.
Target Transition
Analyzing Data on the Trace Using the Marker
Function
Select Positive as the transition type.
Select Negative as the transition type.
Select both Positive and Negative as the
transition type.
Function
Execute the target search.
Execute the left search.
Data Analysis
137