Agilent Technologies ENA Series User Manual page 289

Figure 14-1 Transmission Characteristics of a SAW Bandpass Filter (440 MHz to 3 GHz, linear
sweep)
The measurement conditions are determined for each frequency range. Here, the segment
sweep is performed following the sweep conditions shown in Table 14-2.
Table 14-2 Determining the Sweep Conditions (Using markers shown in Figure 14-1).
Chapter 14
Measuring the SAW Bandpass Filter Using the Segment Sweep
Frequency Range
Start Stop
915 MHz
440 MHz
(Marker 1)
915 MHz 980 MHz
(Marker 1) (Marker 2)
980 MHz 1.035 GHz
(Marker 2) (Marker 3)
1.07 GHz 2 GHz
(Marker 4) (Marker 5)
2.6 GHz
3 GHz
(Marker 6)
Measurement Examples
Measurement Conditions
Number of Points IF Bandwidth
47 70 kHz
130 100 kHz
55 70 kHz
93 70 kHz
41 70 kHz
281