Enabling Control Of E5091A - Agilent Technologies ENA Series User Manual

Operational procedure
Step 1. Press
Step 2. Press
control line.
Step 3. Press
the real panel of the E5091A. (Figure 13-3 on page 272)
Step 4. Press
Step 5. Use the corresponding softkey to set the control line of the E5091A.
Softkey
Line 0
Line 6
Step 6. Execute Step. 3 through Step. 5 for all channels for which you want to perform sweep.

Enabling control of E5091A

If you enable the control of the E5091A, switching the measurement path and the output
function of the control line of the E5091A during measurement become available.
NOTE
The E5070A/E5071A needs about 3 ms to control the E5091A when you enable the control
of the E5091A. Notice that, if the E5091A is not connected to the E5070A/E5071A, the
E5070A/E5071A does not need any additional time to control the E5091A regardless of
this setting.
When you disable the control of the E5091A, the E5070A/E5071A does not need any
additional time to control the E5091A regardless of connecting the E5091A to the
E5070A/E5071A.
Operational procedure
Step 1. Press
Step 2. Press
NOTE
The enable (
for all channels.
13
- to display the E5091A setup menu.
E5091A Setup
or
and then select the ID of the E5091A. The ID is set with the bit switch on
Select ID
to the setting menu of the DUT control line.
Control Lines
, , , , ,
Line 1 Line 2 Line 3 Line 4 Line 5
,
Line 7
- to display the E5091A setup menu.
E5091A Setup
to enable (
E5091A Control ON
)/disable ( ) setting of the control function of the E5091A is executed
ON OFF
to activate a channel for which you want to set the
Function
, Set / of each line of the control line.
High Low
) the control of the E5091A.
Controlling E5091A
Setting E5091A
275