Agilent Technologies ENA Series User Manual page 137

Softkey
Marker 3
Marker 4
More Markers
More Markers
More Markers
More Markers
More Markers
Ref Marker
Step 5. Change the marker stimulus value in the entry area. This operation enables you to move the
marker to a point on the desired trace.
The value in the entry area can be changed by one of the following methods.
NOTE To change the value in the entry area, the figure in the box should be highlighted. If the
figure is not highlighted, press the softkey for the marker you are using (
marker 9
• Enter a numeric value using the ENTRY block key on the front panel.
• Turn the rotary knob (
• Press the up or down arrow key (
• Using the mouse, click one of the buttons (st) on the right side of the entry area.
You can move the marker by dragging and dropping either one of the marker position
pointers above and below the graph (ts) (pressing the button on the object to be moved
and releasing the button on the destination). In rectangular display format, you can move a
marker itself by dragging and dropping it.
Step 6. When using other markers, repeat Step 4 and Step 5.
Step 7. Read the marker stimulus value and marker response value displayed in the upper-left part
of the trace screen.
Step 8. To turn off marker(s), press the
Chapter 6
Analyzing Data on the Trace Using the Marker
-
Marker 5
-
Marker 6
-
Marker 7
-
Marker 8
-
Marker 9
, ), or to highlight the figure.
Ref Marker
) on the front panel.
Clear Marker Menu
Data Analysis
Function
Turn on marker 3, which has been turned off;
activate marker 3.
Turn on marker 4, which has been turned off;
activate marker 4.
Turn on marker 5, which has been turned off;
activate marker 5.
Turn on marker 6, which has been turned off;
activate marker 6.
Turn on marker 7, which has been turned off;
activate marker 7.
Turn on marker 8, which has been turned off;
activate marker 8.
Turn on marker 9, which has been turned off;
activate marker 9.
Turn on the reference marker, which has been
turned off; activate the reference marker.
marker 1
) on the front panel.
and then press one of the softkeys as
to
129