Initializing The Contents Of The Bin Counts To Zero (Resetting The Counter) - Agilent Technologies Twelfth 4287A RF LCR Operation Manual

Figure 8-16 Bin Count Results dialog box
NOTE To close the Bin Count Results dialog box, press the
The BIN Count results listed in the dialog box are those obtained when you pressed the
DISPLAY
bin sorting are run when the dialog box is on display, you will have to close it once and
then press the

Initializing the contents of the bin counts to zero (resetting the counter)

The contents of all bin counts (i.e., value in the counter) can be initialized (resetting) to
zero using the following procedure:
Step 1. In the front panel Measurement Block, press the
menu.
Step 2. In the softkey menu, press the
softkey menu.
Step 3. In the softkey menu, press the
zero.
Chapter 8
softkey. If the contents of the bin count are updated because measurement and
softkey again to redisplay it.
DISPLAY
BIN COUNT MENU
CLEAR
Sorting According to Measurement Results
button.
OK
key to display the Prmtrs softkey
[Prmtr]
to display the BIN COUNT MENU
key to initialize the contents of all bin counts to
Bin Count Function
191