Agilent Technologies ENA Series User Manual page 165

Step 5. Press
Select Circuit
Step 6. Select a matching circuit model (see Figure 7-5).
Softkey
None
Series L - Shunt C
Shunt C - Series L
Shunt L - Series C
Series C - Shunt L
Shunt L - Shunt C
User
Step 7. Specify the values of the elements in the selected circuit model.
Softkey
C
G
L
R
Step 8. Repeat Step 3 to Step 7 to set up the matching circuit for each port used.
Step 9. Press
Port Matching
Step 10. Press .
Return
Step 11. If
Fixture Simulator
Chapter 7
Determining Characteristics After Adding a Matching Circuit
.
Function
No matching circuit is added.
Select a circuit model consisting of a series inductor and a shunt
capacitor.
Select a circuit model consisting of a shunt capacitor and a series
inductor.
Select a circuit model consisting of a shunt inductor and a series
capacitor.
Select a circuit model consisting of a series capacitor and a shunt
inductor.
Select a circuit model consisting of a shunt inductor and a shunt
capacitor.
Select the circuit model defined in the user file imported by
performing Step 4.
Function
Specifies the capacitance [F].
Specifies the conductance [S].
Specifies the inductance [H].
Specifies the resistance [W].
to turn the matching circuit function
is , press the key again to turn it
OFF
Fixture Simulator
.
ON
.
ON
157