Agilent Technologies ENA Series User Manual page 274

Setting and Using the Control and Management Functions
System Recovery
Step 5. When "Recover Hard disk (C drive) [Y, N]?" is displayed, press
keyboard. If you want to quit the system recovery, press
E5070A/E5071A as usual.
Step 6. The following message appears. This is the final confirmation message asking whether you
want to start the system recover. Press
you want to quit the system recovery, press
===============
SYSTEM RECOVERY
===============
This process will recover the system drive (C:) of this
instrument to the factory-shipment state.
Please refer to the Operation Manual for more information.
This is the last chance to quit the recovery process
Continue [Y,N]?
Step 7. The system recovery will be complete in about 15 minutes. The following message is
displayed during the system recovery.
===============================
SYSTEM RECOVERY IN PROGRESS....
===============================
System recovery in progress.
Please DO NOT TURN THE POWER OFF DURING THIS TIME.
CAUTION Never turn off the power during the system recovery because doing so may cause
serious damage to the E5070A/E5071A.
Step 8. After the completion of the system recovery, the System Setting Change dialog box as
shown in Figure 12-16 appears. Click the
Figure 12-20 System Setting Change dialog box
266
to start up the
on the keyboard to start the system recovery. If
to start up the E5070A/E5071A as usual.
It takes about 30 minutes.
It takes about 30 minutes.
button to restart.
Yes
on the
Chapter 12