Agilent Technologies ENA Series User Manual page 133

Step 3. Press the softkey that corresponds to the desired trigger mode.
Softkey
Hold
Single
Continuous
Hold All Channels
Continuous Disp Channels
Step 4. Repeat Step 1 to Step 3 until all channels are set for the respective trigger mode.
3. Generating the Trigger
Next, it is necessary to generate a trigger using the trigger source selected in "1. Selecting a
Trigger Source" on page 124.
NOTE
Once the internal trigger source is selected, a series of triggers will be continuously
generated as soon as the setting becomes effective.
Pressing
Chapter 5
Setting Up the Trigger and Making Measurements
Function
Sets the active channel trigger mode to the hold sweep mode
Sets the active channel trigger mode to the single sweep mode.
Sets the active channel trigger mode to the continuous sweep
mode.
Sets all channel trigger modes to the hold sweep mode.
Sets trigger modes of all displayed channels (
to the continuous sweep mode.
- during a sweep forces the analyzer to abort the sweep.
Restart
Making Measurements
- )
Display
125