Agilent Technologies ENA Series User Manual page 250

Optimizing Measurements
Performing a Segment-by-Segment Sweep (Segment Sweep)
Step 5. Repeat entering each item in the following table and adding a segment (line) to create the
segment table.
Start
Stop
Center
Span
Points
IFBW
Power
Delay
Sweep Mode
Time
To create the segment table, use the following keys.
Hardkey
Softkey
Delete
Add
Clear Segment Table
OK
242
Set the start value of the sweep range.
Set the stop value of the sweep range.
Set the stop value of the sweep range.
Set the span value of the sweep range.
Set the number of points.
Set the IF bandwidth.
Set the power level. The power range is common to the setting for the linear/log
sweep ( -
Power Ranges
Set the sweep delay time.
Set the sweep mode. Select one of the following items.
Stepped mode
STD STEPPED
Swept mode
STD SWEPT
Fast stepped mode
FAST STEPPED
Fast swept mode
FAST SWEPT
Set the sweep time. To specify the auto setting (
time.
Function
If you select a cell and then press this key, you enter into the mode in
which you can edit the cell character by character. If you change a value
and then press this key, the value is entered into the cell.
Move up and down in the cell selected in the segment table. In the
character-by-character edit mode, you can select an item or perform the
step change of data.
Move right and left in the cell selected in the segment table.
Function
Deletes the line in which the selected cell is included.
Adds a new line above the line in which the selected cell is included.
- Resets the segment table. As a result, segment 1 that is initialized
remains.
).
), enter 0 as the sweep
AUTO
Chapter 11