Matchmarks
Matchmarks
PROPELLER SHAFT
INSTALLATION
1.
(a)
(b)
(c)
Z15303
(d)
2.
(a)
(b)
(c)
HINT:
Z15304
Make sure the bearing is installed with the drain hole facing
downwards.
(d)
(e)
Matchmarks
Q07228
−
PROPELLER SHAFT ASSEMBLY (4WD)
INSTALL FRONT PROPELLER SHAFT
Align the matchmarks on the propeller shaft and differen-
tial flanges, and connect the flanges with the 4 bolts, nuts
and washers.
Torque the 4 bolts.
Torque: 74 N·m (754 kgf·cm,54 ft·lbf)
Align the matchmarks on the propeller shaft and transfer
flanges, and connect the flanges with the 4 nuts and
washers.
Torque the 4 nuts.
Torque: 88 N·m (897 kgf·cm, 65 ft·lbf)
INSTALL REAR PROPELLER SHAFT
Align the matchmarks on the propeller shaft and differen-
tial flanges, and connect the flanges with the 4 bolts,
washers and nuts.
Torque the 4 bolts.
Torque: 88 N·m (897 kgf·cm, 65 ft·lbf)
Temporarily install the center support bearing with the 2
mounting bolts.
Align the matchmarks on the propeller shaft and transfer
flanges, and connect the flanges with the 4 nuts and
washers.
Torque the 4 nuts.
Torque: 88 N·m (897 kgf·cm, 65 ft·lbf)
PR−15
PR05P−02